#93 Menu Mode Programming; #93 Main Menu Options - ADEMCO VISTA-120 Installation And Setup Manual

#93 Menu Mode Programming

This section provides the following information:
• #93 Menu Mode main menu options
• Zone Programming
• Serial Number Programming
• Report Code Programming
• Alpha Programming
• Device Programming
• Relay Programming
• Relay Voice Descriptors
• Custom Index Programming (Telephone Module substitute words)

#93 Main Menu Options

After programming all system related programming fields in the usual way, press #93 while
still in programming mode to display the first choice of the menu driven programming
options, which are as follows:
ZONE PROG?
0=No
SEQUENTIAL LEARN?
0=no
REPORT CODE PROG?
0=no
ALPHA PROG?
0=no
SECTION 21
The following fields should be programmed before beginning: 2*00: Number of
Partitions; 1*32: RF receiver type.
For programming the following:
1=Yes • Zone Number
• Zone Response Type
• Partition Number for Zone
• Dialler report code for zone
• Input Device Type for zone (whether RF, polling loop, etc.)
For programming the following:
1=yes
• Input Device Type for zone (whether RF, polling loop, etc.)
• Enrolling serial numbers of 5800 series transmitters & serial
polling loop devices into the system (all other zone characteristics
must be pre-programmed).
For programming the following:
1=yes
• Alarm report codes for zones
• Restore & supervisory codes
• All other system report codes
For entering alpha descriptors for the following:
1=yes
• Zone Descriptors
• Installer's Message
• Custom Words
• Partition Descriptors
• Relay Descriptors
– 87 –