Communication Programming Guide - ADEMCO VISTA-120 Installation And Setup Manual

Field # Low Speed
*46, *48 Choose transmission
speed and frequency
*52, *53 Send as either 4+2
or expanded
*79, *80 Enables alarm restores
*49 Add checksum digit
*50 Sescoa/Radionics;
Selects fixed digit time
instead of fixed interdigit.
NOTES Note: Low Speed will
not send 3+2
messages. Zone ID
digit is suppressed.
Loading communication defaults results in the following
Low Speed
(*94*80)
ADEMCO Express
(*94*81)
ADEMCO High Speed
(*94*82)
ADEMCO's Contact ID
(*94*83)

COMMUNICATION PROGRAMMING GUIDE

Contact ID
No effect
No effect
Enables alarm restores
No effect
No effect
• Selects low speed, standard format, with no checksum, for both phone
numbers.
• Assigns the following report codes:
03 for zones 002-047, 056-128
01 for zones 001 & 048-055 (fire zones)
02 for zones 062, 063 (panic trans), & 995, 996, 999 (keypad panics)
09 for all alarm restores
• Enables all zone type restores.
For "expanded" reporting, enable fields *52 and *53.
• Selects Ademco express reporting format, with checksum, for both phone
numbers.
• Report codes for zones 1-99, RF receiver, and keypad panics are sent as their
respective zone ID numbers (01-86, 88-91, 95-99), Duress is sent as "DD".
Alarm restore is "E" + 2nd digit.
• Enables all zone type restores.
• Selects Ademco High Speed format, with no checksum, for both phone
numbers.
• Zone reporting is assigned to channels as described later in this section.
• Enables all zone type restores.
• Enables Duress to be sent.
• Selects Contact ID format for both phone numbers.
• Reporting is enabled for all zones.
• Enables all zone type restores.
• Refer to the SYSTEM COMMUNICATION section for event code
definitions.
High Speed
No effect
No effect
Enables alarm restores
Add checksum digit
No effect
Express
No effect
No effect
Enables alarm restores
No effect
No effect
– 133 –