Table of Contents
Advertisement
Connecting a
4100SM Module
for Direct Wire
Downloading
CONTROL/COMM ACCESS:
Read Only: able only to Upload and arm the system.
DISARM, BYPASS, or change any information.
Part Read/Write: able to ARM, BYPASS, UPLOAD, DOWNLOAD but
cannot shutdown the system.
Full Read/Write: able to perform all control and status commands, as
well as shutdown all or part of the system.
NOTES:
1. Each time the Control panel is accessed successfully, a PROGRAMME
TAMPER report (*81) is sent to central station, if programmed.
2. When downloading, the keypad displays "MODEM COMM."
3. Whenever a download or a save is done, an automatic time stamp is done,
indicating the date and time of the last download (or save) and the
operator ID number.
4. The average time for a complete download, including
hang-up and call-back is under 4 minutes.
5. A complete hard copy of each individual account can be obtained by
connecting a printer to the computer. Refer to your computer owner's
manual or contact your distributor for printer recommendations.
The Control can be downloaded without using a modem or telephone line by using
VLINK ® Software and a 4100SM Serial Module. The direct wire downloading
connection is to be temporary, and is not part of the permanent installation. Direct
wire downloading is meant as a tool for the installer during the installation
process.
The connections between the Control and the 4100SM are different than those
shown in the 4100SM Installation Instructions. See the diagram below for correct
connections. In addition, when the "green" wire is referred to in step 2 of the IN CASE
OF DIFFICULTY section of the 4100SM Instructions, use the "violet" wire.
Connector J8, located above connector J7 on the right hand side of the main PC
board (see the Summary of Connections diagram on the inside back cover of this
manual), is intended to be interfaced to either a local serial printer (see EVENT
LOG PRINTER CONNECTIONS) or a computer.
computer as shown below.
computer differs from that used when connecting a serial printer.
1
2
3
Figure 31: Direct Wire Downloading Connections
-
Note that the violet wire connection for a
4
5
6
7
8
9
J8 CONNECTOR
NU
4142TR CABLE (SUPPLIED WITH 4100SM)
To TB6 Aux. Power (+)
(25mA current draw)
To TB7 Aux. Power (-)
Not able to
initial call-up,
Make connections to a
4100SM SERIAL MODULE
8
+ PWR
7
- (GND)
6
RXD
5
not used
4
not used
3
TXD
2
not used
1
not used
RED
BLUE WHITE
- 141 -
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
