ADEMCO VISTA-120 Installation And Setup Manual page 64

–56–
Use the [3] & [1] keys to scroll to the next and previous screens
respectively:
ALARM EVENT LOG
TYPE CCC UUU
CHECK EVENT LOG
TYPE CCC UUU
BYPASS EVENT
LOG
TYPE CCC UUU
OP/CL EVENT LOG
TYPE CCC UUU
SYSTEM EVENT LOG
TYPE CCC UUU
ALL EVENT LOG
TYPE CCC UUU
To display the events in a particular category, press [8] at the desired
category screen.
If in Display Mode, the most recent event is displayed. Press [1] to display
older events, press [3] to go forward in time.
If in Print Mode, the first press of [8] will cause the printer to print all events
in that category, with each event automatically scrolled on the display
keypad. The following is a typical display:
P8 01/01 12:02AM
BURGLARY 003
After the last event in the selected category has been displayed (using either
the [1] or [3] keys), the following will appear for a few seconds:
END OF EVENT LOG
TYPE CCC UUU
CLEAR EVENT LOG
0=NO 1=YES
ARE YOU SURE?
0=NO 1=YES
SCREEN DEFINITIONS
RECENT Events since last CLEAR
COMPLETE Displays all events
TYPE Type of event (Burg., Fire, etc.)
CCC Zone (contact) number
UUU User number
Displays time/date for zones that have either
caused an alarm or have been restored in selected
partition.
Displays time/date for zones that have caused a
trouble or supervisory condition in selected
partition.
Displays time/date for zones that have been
bypassed in selected partition.
Displays time, date and user number for each
arming and disarming of the system for the
partition selected.
Displays time/date for system problems, such as
AC Loss, communication failure, etc., regardless
of partition.
Displays all categories of events in chronological
order, from most recent to oldest.
Shows burglary alarm occurred in zone 3 of
partition 8, at 12:02AM on January 1.
Press [1] if Event Log is to be cleared from
memory. All events in the log will still be
displayed if the COMPLETE option is selected.
Only those events occurring from the time of the
CLEAR command will be displayed if RECENT
display option is selected. Press [0] if event log is
not to be cleared at this time.
If [1] is pressed, the following will appear:
Press [1] if it is desired to clear the event log.
Press [0] if event log is not to be cleared.