Report Code Programming - ADEMCO VISTA-120 Installation And Setup Manual

At any time during this step, you may press the [*] key on the keypad or the upper left-hand
button of the programme tool if you are satisfied with the serial and loop number
combination that has been enrolled, regardless of whether or not the enrolled input has
been "confirmed." This will ready the system to enroll the next serial number device.
If the incorrect device has been enrolled, press the [#] key on the keypad or the upper right-
hand button of the programme tool to delete the serial number and return to the "LEARN
S/N" prompt. A single long beep will be heard from the keypad to verify pressing of the
upper right-hand button. Then, press "1" (Yes) or press the upper left-hand button of the
programme tool (a single short beep will verify the system is ready for enrolling) and re-
activate the proper device or device loop input.
When you have finished programming all zones, test each using the system's TEST mode.
Do not use the Transmitter ID Sniffer mode for this, as it will only check for transmission of
one zone on a particular transmitter, NOT the zones assigned to each additional loop, and
will NOT verify polling loop type.

Report Code Programming

All report codes are entered using #93 menu mode programming, either through Report
Code Programming, or through the Zone Programming mode while entering other zone
information. In the Vista-120, reports are divided into six categories. These categories
represent the main menu options found in the Report Code Programming mode. Reports and
the categories in which they are found are as follows:
The programming sequence that follows assumes that you will be entering all reports for the
system at one time. In actuality, you may skip from one main menu option to another by
pressing 0 (N) to each main menu option. Main menu options are highlighted in bold text.
To enter report codes, do the following:
Enter Programme mode [Installer Code] + 8 0 0 0. Then press #93. Enter (N) to the main
menu options until the Report Code Programming option is displayed.
REPORT CODE PROG
1 = YES
ALARM CODES
Zone Alarm Reports
SYSTEM GROUP #2
Arm Stay Early Open
Time Set, Log Reset
Log 50%, 90% Full
Event Log Overflow
Autobypass by Zone
Autobypass by User
Recent Close
Press 1 (Y) to enter to Report Code Programming
0 = NO 0
mode.
RESTR, SUPV. CODES
(for groups of 16 zones)
Alarm Restore
Trouble
Trouble Restore
Bypass
Bypass Restore
SYSTEM GROUP #3
Early Close
Late Open
Late Close
Failed to Open
Failed to Close
Auto-Arm Failed
Schedule Change
SYSTEM GROUP #1
Closing (arm away)
Opening (disarm)
System Low Battery
Low Battery Restore
AC Mains Loss
AC Mains Restore
Periodic Burg. Test
Power
Cancel
Programme Tamper
Callback Request
– 95 –