Setting The Real-Time Clock - ADEMCO VISTA-120 Installation And Setup Manual

Setting The Real - Time Clock
This section provides the following information:
General Information
Setting the Time and Date
– 142 –
SECTION 25
• General information about the real-time clock
• Setting the time and date
This system provides a real-time clock, which must be set in order for the
system's event log to keep track of events by time and date. It must also be
set in order to execute scheduling programs (time-driven events).
Use a keypad to set the real-time clock, or set the clock via the Downloader
software. Only users with installer or master authority level can set the real-time
clock.
1. Enter installer or master code + # 63. Typical display shows
2. The day of the week is automatically calculated based on the date
entered. Time and date entries are made by simply entering the
appropriate hour, minute, day, month, and year.
Press the key to accept the entered value. The cursor then moves to
the right.
Press the key to move the cursor to the left of the display, to the
previous position.
Enter the correct hour then press
the correct entry.
Press again, then press any key 0-9 to set AM/PM (or enter in 24
hour format, if selected in field 1*55). Press any key again to change AM
to PM, or PM to AM.
Press to move cursor to the day position and enter the correct day
using a 2-digit entry.
Press and enter the correct month.
Press and enter the correct year.
3. Exit clock mode by pressing the
position.
TIME/DATE –– THU
12:01 AM 01/01/90
to move to the minutes and make
key after the cursor is in the year