ADEMCO VISTA-120 Installation And Setup Manual page 102

If the first zone number entered does not have one or more of the above attributes, the system
will search its database for the first zone that does and will display it on the next screen.
010 INPUT S/N
Axxx xxxx
If you do not wish to enroll the zone displayed, press the # key on the keypad or the upper right-
hand button on the programme tool (a long beep will be heard to verify). The following prompt
will appear:
010 LEARN S/N?
0 = NO, 1 = YES 0
ENTER ZN NUM.
(
000 = QUIT)
010 INPUT S/N
A 022-4064
010 CONFIRMED SL:1
A022-4064
– 94 –
This prompt is displayed when the system has found the next
zone which needs to be enrolled. The system will respond to the
first serial number transmitted.
enrolled by one of two methods:
a) Enter the 7-digit serial number printed on the device.
or
b) Activate the device (e.g., press a button, open or close a door,
etc.).
To enroll now, enter "1" (YES). If "0" (NO) is entered, the
following prompt will appear.
Enter the next zone number to be enrolled (e.g., zone 010). The
system will search for that zone and will display the "ENTER
010
ZONE NO." prompt. If you wish to exit the enrollment mode
completely, enter 000 and press [*].
The system will enroll the first serial number heard, display the
serial numbers, and cause the keypad to beep twice.
If the serial and loop number combination is already present in
the system, the keypad will sound a single long beep and display
the word "DUPLICATE" along with the serial number, and the
number of the zone containing the serial/loop number
combination.
The system will then enter an optional confirmation mode so
that the operation of the actual programmed input can be
confirmed. Activate the loop input or button that corresponds to
this zone.
programming of every device before proceeding to the
next zone.
When the system sees activity on the appropriate input, it will
beep three times and display the confirmation message. Press
[*] or the upper left-hand button of the programme tool when
you are ready to enroll the next serial number device.
The system will search for the next zone that does not have a
serial number associated with it. If one is found, the system
will return to the "INPUT S/N" prompt for the remaining
zones.
After all zones have been displayed, whether enrolled or not, the
"ENTER ZN NO." prompt will appear. Enter "000" to exit the
Sequential mode and return to data field programming mode.
A serial number may be
We recommend that you confirm the