Manual Relay Activation Mode (#70) - ADEMCO VISTA-120 Installation And Setup Manual

Manual Relay
Activation Mode
(#70 Mode)
– 154 –
The system allows users to manually activate relays/X-10 modules by keypad command
using either the keypad or a telephone keypad (if VIP module is used). The user will be
prompted (by keypad alpha display or telephone voice module).
To activate relays from a keypad, enter 4-digit security code + [#] +70.
To activate relays using a telephone and telephone module, first dial the 2-digit phone
access code. When the system acknowledges the access, enter 4-digit security code + [#]
+ 70. The following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT 01
nn DEVICE IS OFF
Key 0=OFF , 1=ON
nn DEVICE IS OFF
Key THE "*" KEY
Voice: "ENTER DEVICE CODE NOW"
Enter the 2-digit number of the relay/X-10 module to be
activated.
Voice: " voice descriptor
descriptor ON ENTER 1, FOR voice descriptor OFF ENTER 0"
Press 0 or 1 to turn the device off or on respectively. "nn"
represents the 2-digit relay/X-10 module number and voice
descriptor is the relay voice descriptor programmed by the
installer.
Voice: " voice descriptor DEVICE nn ON/OFF. TO EXIT ENTER
00 NOW"
From a keypad, press
NO. prompt will appear. From a telephone keypad, enter 00 to
exit, or enter the next relay number to be programmed. The
current on/off state of that relay will be annunciated.
Alternatively, if 6 seconds elapses with no key depression, the
telephone module will annunciate the "ENTER DEVICE
CODE NOW" message.
DEVICE nn ON/OFF.
to continue. The ENTER DEVICE
FOR voice