4285 Vista Interactive Phone (Vip) Module; Mounting The 4285 Vip Module - ADEMCO VISTA-120 Installation And Setup Manual

4285 Vista Interactive Phone
This section provides the following information:
General
Information
Facts You Need to
Know
Mounting the 4285
VIP Module
SECTION 10
(VIP) Module
• General information about the 4285 VIP module
• Mounting and wiring the 4285 VIP module
• Checkout procedure for the 4285 VIP module
The 4285 VIP Module is an add-on accessory that permits the user to access the
security system and relays via a TouchTone (DTMF multifrequency) phone
(either from the premises or by calling the premises from a remote location). This
module must be enabled in the #93 Device Programming Mode as device address
4, and must be assigned to a partition.
Only one VIP Module can be used in a security system and partition assignment is
done via #93 Menu Mode–Device Programming.
The 4285 VIP Module enables the user to do the following via a DTMF
multifrequency telephone:
• Receive synthesized voice messages over the phone regarding the status of the
security system.
• Arm and disarm the security system and perform most other commands using
the telephone keypad.
• Control 4204 relays and/or Powerline Carrier devices using the #70 relay
mode.
• Provides voice annunciation over the phone to confirm any command that is
entered.
• The VIP Module can announce many of the same words that would normally
be displayed on a keypad under the same system conditions (see the words in
bold in the Alpha
PROGRAMMING section). If the VIP module cannot annunciate a word in a
zone descriptor, it will not annunciate the descriptor at all, but will still
annunciate the zone number.
• Remote access to the VIP Module can be toggled on and off by using the
[Security Code] + # 91 command (see VIP Module instruction manual). You
must use the master or installer code only.
• The VIP Module reports trouble as zone 804 (800 + ECP device address 04 =
804) if data communication with the control is lost.
• Detailed operating instructions for phone access to the security system are
provided with the VIP Module. In addition, a Phone Access User's Guide is
supplied with the VIP Module for the user of the system.
The VIP Module may be mounted in the control cabinet if space is available or, if
this is not possible, on the side of the cabinet or adjacent to it. Pry off the VIP
Module's cover prior to wiring.
1. When the VIP Module is mounted inside the control cabinet, attach it to the
cabinet's interior surface with double sided adhesive tape. You may leave the
module's cover off if it is mounted within the cabinet.
Do not mount the VIP Module on the cabinet door or attempt to attach it to the PC
board.
Vocabulary list found in #93 MENU MODE
– 43 –