Sequential Mode Programming - ADEMCO VISTA-120 Installation And Setup Manual

Sequential Mode Programming (this section has been revised from previous manuals)
Usually, serial numbers are enrolled during zone programming. If not, use #93 menu mode
to enroll serial numbers (for example, if all other programming was done via downloading).
Use this mode only after all other zone information has been programmed, including transmitter loop
numbers.
1. Enter data field programming mode: installer code + 8 0 0 0.
2. From data field programming mode, press #93 to display the "ZONE PROG?" prompt.
3. Press 0 (NO) repeatedly until the "SEQUENTIAL LEARN?" prompt appears.
SEQUENTIAL LEARN?
0=no 1=yes
If the system has been set up to use 5800 series RF, and a programme tool has not been
programmed, the following "PROGRAM TOOL" prompt will be displayed. If the system has not been
set up to use 5800 series RF or a programme tool has already been programmed, the system will
advance to the "TECHNOLOGY TYPE" prompt.
PROGRAM TOOL?
0 = NO, 1 = YES
010 INPUT S/N: L
Axxx-xxxx
010 PROG AS BR: 3
A123-4567
TECHNOLOGY TYPE
WIRELESS
ENTER ZN NO.
(000 = QUIT)
Zone Number Entered
To enroll or delete a device's serial number, enter 1 (yes). Enter 0
to move to skip to the next main menu option.
If a programme tool is being used, enter "1." If not using a tool,
enter "0". When a "0" is entered, the system will advance to the
0
"TECHNOLOGY TYPE" prompt.
If "1" is entered, the system will prompt for the unit's serial
number. Enter the programme tool's serial number using one of
the following methods:
a) Enter the 7-digit serial number for the transmitter, or
b) Press any button on the transmitter. The keypad should beep
three times and display the serial number of the tool.
In this example, the serial number is A123-4567. Once enrolled,
the upper left-hand button of the programme tool can be pressed to
3
ready the system for enrolling a device into the system.
The serial number for the programme tool will only remain
in the system until the programming mode is exited.
(Entering *97 will not delete the tool.)
Press [*] to continue or press the [#] key to back the system up to
the "PROGRAM TOOL ?" prompt.
Enter the type of device(s) to be enrolled as follows:
0 = Wireless (Default)
0
 1 = Polling Loop
Default
2 = Both
Press
Enter the first zone number to be enrolled (e.g., zone 010).
010
Press

The system will, starting with this zone number, search for the
first device which had all of the following attributes pre-
programmed in Zone Programming:
a) An input type of RF, UR, BR, or SL (if serial polling
loop devices enabled) programmed
b) A loop number programmed
c) No serial number programmed
to continue.
to continue.
– 93 –