Rf Serial Number Clear Mode - ADEMCO VISTA-120 Installation And Setup Manual

RF Serial Number Clear Mode

This mode may be used in the event that an undesired transmitter has been enrolled during
sequential enrolling, causing each subsequent serial number to be assigned to an incorrect
zone. Performing this operation will delete all RF serial numbers, leaving all other zone
information intact. You may then return to Sequential mode to re-enroll wireless
transmitters.
The RF Serial Number Clear mode will not delete polling loop serial numbers.
To clear all RF wireless serial numbers, do the following:
1. Enter programming mode: installer code + 8 0 0 0.
2. From programming mode, press #93 to display the "ZONE PROG?" prompt.
3. Press 0 (NO) repeatedly until the "CLEAR RF SERIAL #?" prompt appears.
CLEAR RF SERIAL#?
1 = YES, 0 = NO
ARE YOU SURE?
1 = YES, 0 = NO
Enter "1" to clear all RF wireless serial numbers. The "ARE YOU SURE?"
prompt is displayed as follows:
0
Enter "1" to clear all RF serial numbers. Re-enter the Sequential mode to
enroll wireless transmitters.
0
— 109 —