Programming Partition Specific Data Fields; Menu Mode Programming - ADEMCO VISTA-120 Installation And Setup Manual

Programming
Partition-Specific
Data Fields
#93 Menu Mode
Programming
To proceed, enter
*05).
Partition-Specific programming fields are skipped.
4. To change to the next page of fields, press *94.
To return to the previous page of fields, press *99.
To program partition-specific data fields once in programme mode, do the
following:
1. Press *91, which will prompt you for the partition number desired.
2. Enter a partition-specific field number (ex. *09) to begin programming. When
the first field's entry is completed, the next partition-specific field will
automatically be displayed.
programmed, the system returns to the global programming fields (page 1
fields). To return to the global programme fields before finishing all fields,
enter any global field number.
3. Repeat this procedure for each partition in the installation.
PROGRAMMING PARTITION-SPECIFIC FIELDS
Enter the partition to be programmed
Enter a partition-specific field # and make entry
After partition -specific fields are programmed,
press *91 to select next partition.
Enter any global field number to return to the global fields at any time.
The #93 Menu Mode is a mode through which much of the system's programming
is done. It offers main menu selections for the following:
Zone Programming
Serial Number Programming
Alpha Programming
Device Programming
Relay Programming
Relay Voice Descriptors
Custom Index Programming (VIP Module substitute words)
Press 0 (NO) or 1 (YES) in response to the displayed menu selection. Pressing 0
will display the next choice in sequence. The keypad will then prompt you with
questions regarding the programming of a particular zone or device.
The following is a list of commands used while in the menu mode.
#93 Menu Mode Key Commands
#93 Enters Menu mode
[ ] Serves as ENTER key. Press to have keypad accept entry.
[#] Backs up to previous screen.
0 Press to answer NO
1 Press to answer YES
00+[ ] Escapes from menu mode, back into data field programming
mode, if entered at the first prompt of each main menu
option.
+ the next data field you wish to programme (ex. press
When all partition-specific fields are
Press *91 to select a partition
– 67 –