Communication Programming - ADEMCO Vista-20HW Installation Instructions Manual

Communication Programming
Introduction
This sectionprovidesinstructionsfor programming thosefields that affectcommunications
betweenthe controlandthe centralstation.
\
Keypad Programming Procedure
1. With at least one Alpha keypad (5137AD or 6139) connected to the
system, power up the system. If necessary, refer to the POWERING
THE SYSTEM section for the power-up procedure. If you had
previously connected the AC transformer to the control panel, you
need only plug in the transformer (to 120VAC outlet) to power up the
system.
2. Enter the programming mode by keying the following on the Alpha
keypad: Installer code (4 1 12)+ !3O 0.
Press *O PABX ACCESS CODE.
I I I I I Enter up to 4 digits if PABX is needed to
access an outside line. If fewer than 4 digits are needed to be
entered, exit by pressing * and next field number (e.g., 41). To
clear entries from field, press *4o*.
Fields * 40, * 41, *42:
Enter up to the number of I
digits shown. Do not fill
unused spaces.
Enter O-9,
#+11 for'*<
# + 12 for%'
# + 13 for a pause
(2.5 sees)
Press *41
Press *42
Press *43
Press *44
Press *45
Press *46
PRIMARY PHONE No.
11111111111
Enter up to 12 digits.
If fewer than 12 digits entered, exit by pressing * and next field
number (e.g., 42). To clear entries from field, press * 41*,%
SECONDARY PHONE No.
111111.11111
1
Enter up to 12 digits.
If fewer than 12 digits entered, exit by pressing * and next field
number (e.g., 43). To clear entries from field, press * -42*.
w
For Fields *43, *44, * 45, and* 46.
Entries are provided for 3 or 4 digits for the primary and
secondary monitoring location.
Enter digits O–9; #+10 = A (O on some receivers); #+11 = B;
#+12 =C; #+13 =D; #+14= E;or# +15= F,
To clear entries from field, press* 43*, * 44*, * 45*, or* 46*.
See blank Programming Form for examples of Account No.
entries.
PRIMARY SUBSCRIBER ACCOUNT. No. (Partition 1)
~ (primary Central StationAccountNumber).
SECONDARY SUBSCRIBER ACCOUNT. No. (Partition 1)
~ (Secondary Central StationAccountNumber).
PRIMARY SUBSCRIBER ACCOUNT. No. (Partition 2)
~ (PrirnaryCentral StationAccountNumber).
SECONDARY SUBSCRIBER ACCOUNT. No. (Partition 2)
~ (Secondary Central StationAccount Number)
Press *47 PHONE SYSTEM SELECT Enter 1 digit (default= O) U
If Central Station Receiver is not on WATS line:
O= Pulse Dial, 1 = Tone Dial.
If Central Station Receiver is on WATS line:
2 = Pulse Dial, 3 = Tone Dial.
-64-