Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

System board and components

14.1.5 Concluding steps

Perform the following procedures to complete the task:
Ê Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
Ê Reinstall the air duct as described in section
on page 100.
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section
information backup / restore" on page
Ê Verify and update time settings as described in section
time settings" on page
770
"Mounting the side cover" on page 120
131.
158.
Upgrade and Maintenance Manual
"Installing the system air duct"
"Mounting the top cover"
130.
128.
"Connecting the server to
"Verifying system
150.
"Verifying the system
(tower
TX300 S7 / RX350 S7