System board and components
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 77
(rack server) or
server).
Ê Remove the air duct as described in section
on page
98.
14.2.1.3 Installing the UFM board
Figure 514: UFM kit
Pre-assembled UFM flash module kit (S26361-F3514-V3):
1
2 GB UFM SLC
A3C40104433
2
UFM spacer
A3C40109081
3
UFM nylon screw
A3C40109082
772
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
Upgrade and Maintenance Manual
75.
"Removing the top cover"
"Removing the system air duct"
TX300 S7 / RX350 S7
74.
(tower