Connecting The Server To The Mains; Securing Power Cords; Mounting A Psu Cable Bracket - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

4.12

Connecting the server to the mains

The PRIMERGY TX300 S7 / RX350 S7 server can be equipped with up to four
hot-plug PSU modules that automatically adjust to any mains voltage in the
range of 100 VAC to 240 VAC. Power redundancy is possible in various PSU
configurations (see section
V
CAUTION!
The server supports a mains voltage in the range of 100 VAC to
240 VAC. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Ê Connect the power cords to the power supply units.
Ê Connect the mains plugs to grounded mains outlets in the in-house power
supply network or power outlets of the rack socket strip (see also
"PRIMECENTER Rack System" assembly guide).

4.12.1 Securing power cords

4.12.1.1 Mounting a PSU cable bracket

If the PSU cable bracket has not yet been mounted to the power supply module,
proceed as follows:
Figure 67: Preparing the PSU cable bracket
TX300 S7 / RX350 S7
"PSU installation sequence" on page
Upgrade and Maintenance Manual
Basic hardware procedures
171).
131