Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Accessible drives

12.5.1.2 Preliminary steps

Before installing a slimline ODD or LSD, perform the following steps:
Ê Shut down the server as described in section
page 69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
I
The front cover only needs to be removed in order to remove
accessible drive dummy covers (see section
drive dummy covers" on page
installed in the server and will be removed in order to install a slimline
ODD or LSD module, skip this step.
Ê Remove the air duct as described in section
on page 98.
Ê Remove the system fan holder as described in section
system fan holder" on page
Ê If the Multibay box is already installed in the server, disconnect all cables
from the slimline ODD or LSD module and remove the box as described in
section "Removing the Multibay box" on page
640
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
77.
386.
Upgrade and Maintenance Manual
"Shutting down the server" on
"Disconnecting the server
75.
"Removing the top cover"
"Removing accessible
610). If the Multibay box is already
"Removing the system air duct"
666.
74.
(tower
"Removing the
TX300 S7 / RX350 S7