Installing The 2X 3.5-Inch Hdd Extension Box; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Installing accessible drive covers
Ê Install accessible drive covers (C26361-K644-C60) into installation bays 2
and 3 of the front cover as described in section
dummy covers" on page

12.6.2.7 Installing the 2x 3.5-inch HDD extension box

Ê If the 2x 3.5-inch HDD extension box is to be reinstalled in the system,
prepare the accessible drive mounting brackets and install the extension box
into installation bays 2 and 3 as described in section
inch HDD extension box" on page

12.6.2.8 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 100.
Ê If applicable, close the front cover and reinstall the ID card as described in
section "Closing the server" on page
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
TX300 S7 / RX350 S7
634.
312.
387.
"Mounting the side cover" on page 120
131.
Upgrade and Maintenance Manual
"Installing accessible drive
"Installing the 2x 3.5-
"Installing the system
"Installing the system air duct"
110.
"Mounting the top cover"
130.
128.
"Connecting the server to
Accessible drives
(tower
687