After Replacing / Upgrading Lan Controllers; After Replacing The System Board; Switching Off The Id Indicator - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX300 S7:

Table of Contents

Basic software procedures

5.2.17.1 After replacing / upgrading LAN controllers

Please note when re-using a replaced LAN controller:

Ê Confirm with the customer whether the LAN controller you have replaced

has been used as part of a LAN teaming configuration.

Ê If LAN teaming has been active, you will need to restore the configuration

using the LAN driver utility after replacing the LAN controller.

Ensure that the controllers have been assigned as primary or secondary

according to your requirements.

For details, refer to the relevant LAN driver manual.

Ê Confirm with the customer whether the onboard LAN controller you have

replaced has been used as part of a LAN teaming configuration.

Ê If LAN teaming has been active, you will need to restore the configuration

using the LAN driver utility after replacing the system board.

For details, refer to the relevant LAN driver manual.

Press the ID button on the front panel or use ServerView Operations Manager

to switch off the ID indicator after the maintenance task has been concluded

successfully.

For further information, refer to section

or to the "ServerView Suite Local Service Concept (LSC)"

Using the ID button on the front panel

Ê Press the ID button on the front panel to switch off the ID indicators.

Using ServerView Operations Manager

Ê In ServerView Operations Manager Single System View and press the Locate

button in the title bar to switch off the ID indicator.

Upgrade and Maintenance Manual

"Locating the defective server" on

TX300 S7 / RX350 S7

Primergy rx350 s7