Connecting A Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.5.3.6

Connecting a backup unit to the expansion card

Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections "Installing a BBU" on page 495
9.5.3.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the air duct as described in section
on page 100.
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 163.
Ê After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
TX300 S7 / RX350 S7
"Mounting the side cover" on page 120
131.
"Looking up changed MAC / WWN addresses"
"Updating RAID controller firmware" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
or "Installing an FBU" on page
"Installing the system air duct"
"Mounting the top cover"
130.
128.
"Connecting the server to
156.
503.
(tower
157.
160.
150.
"Enabling SVOM
493