Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

7.3.9.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 100.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Install HDD / SSD modules or HDD dummy modules into the additional HDD
slots as described in sections
page 214 and
page 220.
I
For detailed information on HDD mounting order, refer to section
inch HDD / SSD configurations" on page
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
TX300 S7 / RX350 S7
387.
110.
"Installing a 2.5-inch HDD / SSD module" on
"Installing a 2.5-inch HDD / SSD dummy module" on
"Mounting the side cover" on page 120
131.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Installing the system
"Installing the system air duct"
197.
"Mounting the top cover"
130.
128.
"Connecting the server to
"2.5-
(tower
291