Removing The Defective Sas Raid Controller; Installing The New Sas Raid Controller; Connecting Cables To The Expansion Card - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Remove the air duct as described in section
on page 98.
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 901.
9.5.3.3

Removing the defective SAS RAID controller

Ê Remove the defective SAS RAID controller as described in section
"Removing the SAS RAID controller" on page
Ê If the RAID card holder on the defective controller is to be reused, remove it
from the board as described in section
on page 483.
9.5.3.4

Installing the new SAS RAID controller

Ê If applicable, install the RAID card holder on the new SAS RAID controller
as described in section
Ê Install the new SAS RAID controller as described in section
SAS RAID controller" on page
9.5.3.5

Connecting cables to the expansion card

Ê Connect SAS cables to the SAS RAID controller.
I
For a complete cabling overview, please refer to section
overviews" on page
492
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
"Onboard indicators and controls" on
"Preparing the SAS RAID controller" on page
482.
863.
Upgrade and Maintenance Manual
"Disconnecting the server
75.
"Removing the top cover"
"Removing the system air duct"
488.
"Preparing the SAS RAID controller"
74.
(tower
483.
"Installing the
"Cabling
TX300 S7 / RX350 S7