Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.5.1.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the air duct as described in section
on page 100.
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 152.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX300 S7 / RX350 S7
"Mounting the side cover" on page 120
131.
"Updating RAID controller firmware" on page
162.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the system air duct"
"Mounting the top cover"
130.
128.
"Connecting the server to
"Enabling Option ROM scan" on
156.
(tower
150.
"Enabling SVOM
"Enabling
487