Front panel and external connectors
13.2.2 Removing the front LAN connector
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
13.2.2.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing the front LAN connector: tool-less
●
13.2.2.2 Preliminary steps
Before removing the front LAN connector, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 77
(rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
742
139.
62.
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
77.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
75.
"Removing the top cover"
TX300 S7 / RX350 S7
74.
(tower