Handling Processor Heat Sinks; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

11.5

Handling processor heat sinks

Upgrade and Repair Units (URU)
Field Replaceable Units (FRU) if thermal paste is involved
Average task duration: 15 minutes

11.5.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing or removing the processor heat sink:
●
– Phillips PH2 / (+) No. 2 screw driver

11.5.2 Preliminary steps

Before installing, removing or replacing the processor heat sink, perform the
following steps:
Ê Shut down the server and disconnect the AC power cord from the system as
described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Remove the air duct as described in section
on page 98.
TX300 S7 / RX350 S7
"Shutting down the server" on page
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
Upgrade and Maintenance Manual
69.
75.
"Removing the top cover"
"Removing the system air duct"
Processors
74.
(tower
595