Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 449

Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
TX300 S7 / RX350 S7
162.
446.
Upgrade and Maintenance Manual
Expansion cards and backup units
156.
"Note on network
166.
"Enabling SVOM
"Enabling
449