Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

6.5.5

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system board carrier as described in section
system board carrier" on page
Ê Reinstall the system board as described in section
board" on page
Ê Reinstall all rear expansion cards into their original slots as described in
section "Installing a memory module" on page
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
Ê Reinstall all fan modules and fan holders as described in the related
sections:
– "Installing the system fan holder" on page 387
– "Installing system fan modules" on page 383
– "Installing the rear fan holder" on page 401
– "Installing rear fan modules" on page 389
Ê Reinstall the air duct as described in section
on page 100.
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect all external cables.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
TX300 S7 / RX350 S7
107.
815.
"Cabling overviews" on page
"Mounting the side cover" on page 120
131.
Upgrade and Maintenance Manual
"Installing the
"Installing the system
547.
863.
"Installing the system air duct"
"Mounting the top cover"
130.
128.
"Connecting the server to
Power supply
(tower
193