System board and components
14.2.2.2 Preliminary steps
Before removing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 77
(rack server) or
server).
Ê Remove the air duct as described in section
on page
98.
776
139.
62.
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
75.
"Removing the top cover"
"Removing the system air duct"
TX300 S7 / RX350 S7
74.
(tower