Installing The Sas Raid Controller - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Figure 310: Installing the RAID card holder
Ê Place the controller on the mounting tabs on the slot bracket (1).
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws (2).
9.5.1.4

Installing the SAS RAID controller

Ê Remove the SAS RAID controller from its protective packaging.
I
For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section
484
"Preparing the SAS RAID controller" on page
Upgrade and Maintenance Manual
483.
TX300 S7 / RX350 S7