Concluding Steps; Replacing The System Fan Holder; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

8.2.1.5

Concluding steps

Perform the following procedures to complete the task:
Ê Close the side / top cover as described in section
on page 113 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
8.2.2

Replacing the system fan holder

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
8.2.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
●
8.2.2.2

Preliminary steps

Before replacing the system fan holder, perform the following steps:
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
TX300 S7 / RX350 S7
"Mounting the side cover" on page 120
69.
70.
Upgrade and Maintenance Manual
"Mounting the top cover"
130.
128.
"Shutting down the
"Disconnecting the server
Fans
(tower
385