Onboard Sas Enabling Key; Installing The Onboard Sas Enabling Key; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

System board and components
14.4

Onboard SAS enabling key

The onboard SAS enabling key needs to be installed in order to enable SAS
connector SAS 1-4 on the system board.

14.4.1 Installing the onboard SAS enabling key

Upgrade and Repair Units (URU)
Average task duration: 5 minutes

14.4.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing the onboard SAS enabling key: tool-less
●

14.4.1.2 Preliminary steps

Before installing the onboard SAS enabling key, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
800
139.
62.
70.
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
75.
TX300 S7 / RX350 S7
74.