Preliminary Steps; Installing A Rear Fan Module - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Fans
8.3.1.2

Preliminary steps

Before installing a rear fan module, perform the following steps:
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
8.3.1.3

Installing a rear fan module

V
CAUTION!
– Do not remove the air duct in order to install fan modules!
In the below figures, the air duct has only been removed for
illustration purposes.
– For fan redundancy and in order to satisfy cooling requirements,
always install both rear fan modules. Operation with only one rear fan
module is not possible.
390
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
Upgrade and Maintenance Manual
75.
"Removing the top cover"
TX300 S7 / RX350 S7
74.
(tower