Removing 3.5-Inch Hdd Modules; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX300 S7:

Table of Contents

Hard disk drives / solid state drives

Removing 3.5-inch HDD modules

Customer Replaceable Units (CRU)

Average task duration: 5 minutes

Preliminary and concluding steps: tool-less

Removing a 3.5-inch HDD module: tool-less

Before removing a 3.5-inch HDD module, perform the following steps:

Ê If the HDD / SSD module to be removed is combined into a RAID array,

please proceed as follows:

Only remove an HDD module combined in a RAID 0

array if defective.

Removing an operational HDD module will

result in data loss!

Removing an HDD module from a RAID 1 or RAID 5

array will not result in data loss.

However, the removed drive needs to be replaced

immediately by an HDD module of the same or larger

After replacing the HDD module, RAID rebuild

will be performed as a background process as

described in section

rebuild" on page

Upgrade and Maintenance Manual

"Performing a RAID array

TX300 S7 / RX350 S7

Primergy rx350 s7