Removing A Memory Module; Installing A Memory Module - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Main memory
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Remove the air duct as described in section
on page 98.
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs as described in section
page 901.

10.4.3 Removing a memory module

Ê Remove the defective memory module as described in section
memory modules" on page

10.4.4 Installing a memory module

Ê Replace the defective memory module as described in section
memory modules" on page
554
69.
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
"Onboard indicators and controls" on
550.
546.
Upgrade and Maintenance Manual
"Shutting down the
"Disconnecting the server
75.
"Removing the top cover"
"Removing the system air duct"
TX300 S7 / RX350 S7
74.
(tower
"Removing
"Installing