Connecting Cables To The System Board - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

System board and components

14.5.4.3 Connecting cables to the system board

Figure 554: Connecting cables to the system board (A)
Ê Run the cables through the cable guide (G) as shown.
Ê Fold the PSU signal cable (T26139-Y4027-V1) as shown. Ensure that it lays
flat against the system board (see close-up).
Ê Connect the power and front panel cables to the system board:
Cable
No.
(T26139-)
System power cable
1
Y3758-V9
PSU signal cable
2
Y4027-V1
Front panel cable
3
Y4015-V1
Front VGA cable
4
Y3994-V101
828
Cabling
from
list no.
Power backplane
4
connector X20
Power backplane
2
connector X25
Front panel
10
module
Front panel
12
module
Upgrade and Maintenance Manual
Cabling
to
plan
System board
connector PWR
System board
connector PSU
CONTROL
System board
connector
FRONTPANEL
System board
connector
FRONT VGA
TX300 S7 / RX350 S7
16.2.2
16.2.2
16.2.1
16.2.1