Hard disk drives / solid state drives
7.3.10 Upgrading to 8x 3.5-inch HDD configurations
Upgrade and Repair Units (URU)
Average task duration: 20 minutes
7.3.10.1 Required tools
Preliminary and concluding steps: tool-less
●
Installing the HDD cage:
●
– Phillips PH2 / (+) No. 2 screw driver
7.3.10.2 Preliminary steps
Before enabling the second 3.5-inch HDD bay, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page
69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 77
(rack server) or
server).
Ê Remove all HDD modules from the server as described in section
"Removing 3.5-inch HDD modules" on page
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
292
139.
70.
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
77.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
75.
"Removing the top cover"
274.
TX300 S7 / RX350 S7
74.
(tower