Preparing The Bbu - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Remove the system fan holder as described in section
system fan holder" on page
9.6.2.3

Preparing the BBU

Figure 316: Connecting the BBU cable
Ê Connect the BBU cable (T26139-Y3987-V2) to the BBU board (Lx-25343-
xxx, BBU08) as shown.
V
CAUTION!
Make sure that the connector side with the three dots points towards you
(see close-up). Otherwise, short-circuits may result!
496
386.
Upgrade and Maintenance Manual
"Removing the
TX300 S7 / RX350 S7