Checking Gpgpu Operation - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units

9.4.1.10 Checking GPGPU operation

Ê Switch on the server as described in section
page 137.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Figure 298: Cabling the GPGPU card
Ê Ensure that the LEDs on the rear side of the GPGPU card are lit green,
indicating sufficient power supply.
Ê If the LEDs are lit red, shut down the server, remove power cords from the
PSU modules and recheck the GPGPU power cabling.
468
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
Upgrade and Maintenance Manual
"Switching on the server" on
"Removing the top cover"
TX300 S7 / RX350 S7
74.
(tower