Preparing The Sas Raid Controller - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Remove the air duct as described in section
on page 98.
9.5.1.3

Preparing the SAS RAID controller

Figure 309: SAS RAID controller with RAID card holder (C26361-K644-B944)
TX300 S7 / RX350 S7
"Extending the server out of the rack" on page
"Removing the side cover" on page 86
Upgrade and Maintenance Manual
Expansion cards and backup units
75.
"Removing the top cover"
"Removing the system air duct"
74.
(tower
483