Table of Contents
Advertisement
Installing a 2.5-inch HDD/SSD module
Figure 59: Inserting the 2.5-inch HDD/SSD module
▶ Pinch the green locking clip (1) and open the locking lever (2).
▶ Insert the HDD/SSD module into a drive bay and carefully push back as far
as it will go (3).
▶ Close the locking lever in the direction of the arrow until it engages (4).
▶ When using a RAID array, add the additional HDD/SSD to the RAID array.
Configuring the RAID array, see the documentation of the RAID
controller, used in your configuration, see
page
26.
Concluding steps
▶ No steps needed.
7.4.3
Removing 2.5-inch HDD/SSD modules
Customer Replaceable
Unit (CRU)
RX4770 M5
Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Maintenance Manual
"Documentation overview" on
Hardware: 5 minutes
149
Advertisement
Table of Contents
