Figure 65: Installing the 3.5-inch HDD module
▶ Insert the HDD module into a drive bay and carefully push back as far as it
will go (1).
▶ Close the locking lever to lock the HDD module in place (2).
▶ When using a RAID array, add the additional HDD to the RAID array.
Configuring the RAID array, refer to the documentation of the RAID
controller, used in your configuration, see
on page
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
7.5.3
Removing 3.5-inch HDD modules
Customer Replaceable
Unit (CRU)
Tools:
tool-less
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
29.
Upgrade and Maintenance Manual
"Documentation overview"
71.
Hardware: 5 minutes
153