Removing 3.5-Inch Hdd Modules - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual
Hide thumbs
Also See for PRIMERGY RX1330 M4:
- Customer service information bulletin (3 pages) ,
- Operating manual (106 pages)
Table of Contents
Advertisement
Concluding steps
No steps needed.
7.4.3
Removing 3.5-inch HDD modules
Customer Replaceable
Unit (CRU)
Tools:
tool-less
Preliminary steps
▶ If the HDD module to be removed is combined into a RAID array, please
proceed as follows:
RAID level
RAID 0
RAID 1
RAID 5
In order to permanently remove an operational HDD module that is part of a
RAID array from the server, you first need to delete the array using ServerView
RAID Manager.
RX1330 M4
Hard disk drive (HDD) / solid state drive (SSD)
Procedure
CAUTION
RAID 0 provides no data redundancy.
In case of an HDD module is defect, all
data are lost!
Removing an HDD module from a RAID 1 or RAID
5 array will not result in data loss. However, the
removed drive needs to be replaced immediately
by an HDD module of the same or larger capacity.
After replacing the HDD module, RAID
rebuild will be performed as a background
process, see
rebuild" on page
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Performing a RAID array
87.
143
Advertisement
Table of Contents
