Intake Air Temperature (Iat) Sensor - Isuzu Trooper 1999 Workshop Manual

Installation Procedure
IMPORTANT:
f A special anti-seize compound, P/N 5613695, is used
on the HO2S threads. This compound consists of
glass beads suspended in a liquid graphite solution.
The graphite burns away with engine heat, but the
glass beads will remain, making the sensor easier to
remove.
f New or service sensors will already have the
compound applied to the threads. If a sensor is
removed and is to be reinstalled for any reason, the
threads must have anti-seize compound applied.
1. Apply anti-seize compound or the equivalent to the
threads of the oxygen sensor, if necessary.
2. Install the oxygen sensor on the exhaust pipe in its
original position.
Tighten
f Tighten the oxygen sensor to 55 N·m (40 lb in.).
3. Connect the pigtail to the wiring harness.
4. Connect the negative battery cable.
Intake Air Temperature (IAT)
Sensor
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the engine cover
3. The IAT sensor is located in the intake air duct, behind
the throttle body.
TROOPER 6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS
TS23739
4. Disconnect the electrical connector from the IAT
sensor.
5. Remove the IAT sensor from the intake air duct by
using a rocking motion while pulling the sensor.
Installation Procedure
1. Install the IAT sensor into the grommet in the intake
air duct.
2. Correct the IAT electrical connector.
3. Install the engine cover.
4. Connect the negative battery cable.
6E–469
TS23741
TS23741