Drive Belt; Drive Clutch - Club Car Carryall 1500 2016 Maintenance And Service Manual

15
Clutches

DRIVE BELT

See General Warnings, Section 1, Page 1-2.
The drive belt should be inspected periodically for wear and glazing. If it is excessively worn, frayed, or glazed,
replace the belt.
2171
Figure 15-26 Drive Belt Removal
Drive Belt Removal
1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Remove the outer clutch cover. See Clutch Outer Cover Removal on page 15-37.
3. Grasp the belt midway between the drive and driven clutches and squeeze the belt together as tightly as possible
(Figure 15-26, Page 15-30).
4. Guide the belt over the driven clutch and roll the belt off the driven clutch by rotating the clutch clockwise.
See following CAUTION.
CAUTION
• Make sure your fingers are not underneath the belt when rolling the belt off the driven clutch.
Drive Belt Installation
1. Position the new belt on the drive clutch and then start the belt over the top of the driven clutch.
2. Rotate the driven clutch clockwise and roll the belt over the driven clutch sheaves and onto the clutch.
3. Install the outer clutch cover. See Clutch Outer Cover Installation on page 15-37.
4. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery – Gasoline/Diesel
Vehicles on page 1-4.
See Top-Post Battery: Connecting the Battery- Gasoline/Diesel Vehicles on page 1-4.

DRIVE CLUTCH

See General Warnings, Section 1, Page 1-2.
CAUTION
• Be very careful with the clutches. A clutch that has been dropped will not be properly balanced. If
either clutch is dropped, assume that it is damaged and replace it.
Page 15-30 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
GASOLINE ENGINE, MUFFLER, FUEL
SYSTEM, AND CLUTCHES