Session Syn-Reset; Session Packet-Checksum; Session Session-Intergrity - Zte ZXR10 8900 Series Command Manual

Command
Function
Command Format
Parameter
Description
Example
Command
Function
Command Format
Parameter
Description
Example
Command
Function
Command Format
Parameter
Description
Example

session syn-reset

This command is used to set whether to set session syn-reset.
session syn-reset<on |off >
Parameter
on|off
To set session syn-reset, execute the following command:
# session syn-reset on

session packet-checksum

This command is used to set whether to authenticate packet in-
tegrity.
session packet-checksum <on |off >
Parameter
on|off
To authenticate packet integrity, execute the following command:
# session packet-checksum on

session session-intergrity

This command is used to enable or disable state inspection. State
inspection function is enabled by default. That is, TOS traces the
state of TCP connection. As for TCP, complete three-way hand-
shake is necessary and TCP connection ends with four-way end
handshake or receiving RST packet. As for ICMP echo request,
connection can be established only after request is received. In
some special cases, if a TCP connection is not established through
FW and needs to pass through FW after establishment, state in-
spection function needs being disabled, or connection will get dis-
connected because no corresponding connection can be found on
FW.
session session-integrity <on |off >
Parameter
on|off
To disable session-integrity inspection, execute the following com-
mand:
Confidential and Proprietary Information of ZTE CORPORATION
Description
This sets whether to set session syn-reset.
Description
This command is used to set whether to
authenticate packet integrity.
Description
This sets whether to enable session-integrity
inspection.
Chapter 10 network
113