Zte ZXR10 8900 Series Command Manual page 114

ZXR10 8900 Series Command Manual (FW Volume)
Command
Illustration
Example
98 Confidential and Proprietary Information of ZTE CORPORATION
Parameter
<dst_addr2>
trans_service
<ser_obj>
pat
yes|no
enable
yes|no
before
<number>
1. When defining destination address translation policy, don't
specify destination area and destination vlan.
2. System also translates source port address by default when
translating source address.
3. Attribute resource with no interface binding cannot be used as
address after translation of address translation policy.
Add and enable one source address translation policy so that host
A in intranet uses public network address 201.10.10.1 to access
Description
This is one string and destination object name
after translation is input here.
Tips:
1. This parameter must be one predefi
ned address object name or attribute
name.
2. Only one object can be input here.
3. This parameter is necessary when
adding source address translation
policy.
This sets service resource after translation.
This is the number and service resource name
after translation is input here.
Tips:
This parameter must be one name predefined
in define module.
This sets source port translation switch.
YES means conducting port address
translation to source port and no means not
conducting port address translation to source
port.
Tips:
Yes is the default value.
This sets address translation policy switch.
Yes means enabling this address translation
policy and no means forbidding this address
translation policy temporarily.
Tips:
Yes is the default value.
This places this address translation policy
before one policy.
This is one number, which shall be ID of the
next address translation policy after inputting
this address translation policy.
Tips:
1. This parameter must be id of an added
address translation policy.
2. To view id of system default service
resource, execute the following comm
and:
# define service show default