Log; Log Set - Zte ZXR10 8900 Series Command Manual

ZXR10 8900 Series Command Manual (FW Volume)
Command Format
Command
Illustration
Command
Function
Command Format
Parameter
Description
Command
Illustration
Example
90 Confidential and Proprietary Information of ZTE CORPORATION
alarmnotice test
For convenience of user, FW provides alarm testing function. User
can verify effectiveness of alarm rules through testing after suc-
cessfully adding alarming mode and setting alarm-triggered secu-
rity event.

log

This is FW log management. Here user can set to both transmit
logs on FW to log server for viewing and storage and view and
retrieve partial logs on FW directly.

log set

This command is used to set log server.
log set ipaddr <ipaddress>[port <string>][ logtype <syslog|w
elf>][trans<enable|disable>]
Parameter
set
ipaddr
<ipaddress>
port
<string>
logtype
syslog|welf
trans
enable|disable
Generated FW log data needs to be managed by log server. By
default, IP address of log server is 192.168.1.253, protocol and
port id is udp: 514, log transmission format is syslog, and log is
not transmitted.
To set log server to 192.168.1.25, protocol and port to TCP: 524,
log transmission type to syslog, and permit log transmission, ex-
ecute the following command:
# log set ipaddr 192.168.1.25 port tcp:524
logtype syslog trans enable
Description
This command is used to set log server.
This sets IP address of log server.
This is one string, indicating IP address.
This sets port of log server.
This is one string, indicating port id, in format
of tcp:80 or udp:80.
This sets log transmission format: syslog or
welf
The default option is syslog.
This sets whether to transmit log.
Enables indicates transmitting log and disable
indicates not transmitting log.