Configuring Pvlan; Table 236 Set Pvlan Session Command; Table 237 Set Pvlan Session Delete Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
Isolated port
Purpose
Steps
146 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
An isolated port has complete separation from other ports within
the same PVLAN.
promiscuous port only,
Isolated port forwards traffic to all promiscuous ports only.
ZXR10 2920/2928/2952 supports 8 PVLANs groups, each group
having customized isolate ports and at most 8 promiscuous
ports.

Configuring PVLAN

This topic describes the configuration of PVLAN in ZXR10
2920/2928/2952 .
For the configuration of PVLAN, perform the following steps.
1. To configure the isolate ports and promiscuous ports of
PVLAN to isolate trunk and sharing port/trunk,
command set pvlan session <1-4> add promiscuous
{ port<portid>|trunk<trunkid>}
<portlist>|trunk <trunklist>} in global configuration mode.
This is shown in Table 236.
T 2 3 6 S P V L A N S
A B L E E T
Format
set pvlan session <1-4> add
promiscuous
{ port<portid>|trunk<trunkid>}
isolate {port <portlist>|trunk
<trunklist>}
Result: This configures isolate ports and promiscuous ports
of PVLAN.
2. To delete the isolate ports and promiscuous ports of
PVLAN, use command set pvlan session <1-4> delete
isolate {port
configuration mode.
T 2 3 7 S P V L A N S
A B L E E T
Format
set pvlan session
<1-4> delete
isolate {port
<portlist>|trunk
<trunklist>}
Result: This deletes the isolate ports and promiscuous ports
of PVLAN.
The isolate port communicates with the
but not with any other isolate port.
C
E S S I O N O M M A N D
Mode
global config
<portlist>|trunk <trunklist>}
This is shown in Table 237.
D C
E S S I O N E L E T E O M M A N D
Mode
global config
use
isolate {port
Function
This
configures
isolate ports
and
promiscuous
ports of
PVLAN
in global
Function
This deletes the
isolate ports and
promiscuous ports
of PVLAN