Configuration Through Console Port Connection; Configuration Through Telnet Session - Zte ZXR10 2900 Series User Manual

ZXR10 2900 Series User Manual
Configuration through Console Port
Connection
Configuration through console port connection is the main con-
figuration mode of the ZXR10 2920/2928/2952/2936-FI. For the
operation procedure, refer to Connection Configuration. The user
can also configure the connection when the equipment is running.
Configuration through TELNET
Session
Telnet mode is often used for configuring a remote switch. The
user can log in to the remote switch through the Ethernet port of
the local host. The login username and password must be config-
ured on the switch and ping the IP address of the layer 3 port on
the switch successfully on the local host. (For configuration of IP
address of the layer 3 port, see Configuring IP Port.)
Use the command create user <name>{admin | guest} (the
length of username does not exceed 15 characters) to create a
new management user, the command set user local <name>
login-password [<string>] (the length of login-password does
not exceed 16 characters) to set the login password.
Use the command set user {local | radius}<name> admin-pa
ssword <string> (the length of admin-password does not exceed
16 characters) to set administrator password.
Note:
The default username is admin and the password is zhongxing.
The default management password is null.
Suppose the IP address of the layer 3 port is 192.168.3.1 and
this address can be pinged from the local host. Then perform the
remote configuration as follows:
1. Run the Telnet command on the host, as shown in Figure 35.
44 Confidential and Proprietary Information of ZTE CORPORATION