Alarmnotice; Alarmnotice Add Beep - Zte ZXR10 8900 Series Command Manual

Command
Function
Command Format
Parameter
Description
Command
Illustration

alarmnotice

This is the management to alarm modes of FW. FW system can
trigger alarms automatically according to pre-defined policies and
security alarm events. It can send alarm information to adminis-
trator through loudspeaker, email, console, SNMP, NETBIOS and
other modes. Here user can set related parameters in various
alarm modes.

alarmnotice add beep

This command is used to add one beep alarm.
alarmnotice add <beep> name <string>[<default>]|[freq
<number1> length
<number4>]
Parameter
add
<beep>
name
<string>
<default>
freq
<number1>
length
<number2>
reps
<number3>
delay
<number4>
When the attribute of beep alarm is set to default, the default
values of parameters are as follows:
frep
length
Confidential and Proprietary Information of ZTE CORPORATION
<number2> reps
Description
This command is used to add one beep alarm.
This indicates the alarming mode is beep
alarm.
This sets alarm name.
This is a string, indicating the name of alarm.
This uses the default value of beep alarm.
With this option, the following parameters are
not needed.
This sets beep output frequency.
This is one number, indicating beep output
frequency, in HZ, in range of 1-1000HZ.
This sets beep length.
This is one number, indicating beep length,
in micro-seconds, in range of 1-1000
micro-seconds.
This sets repeat times of beep.
This is one number, indicating beep repeat
times, in times, in range of 1-1000 times.
This sets the interval of two beeps.
This is one number, indicating beep interval,
in micro-seconds, in range of 1-1000
micro-seconds.
440HZ
200 micro-seconds
Chapter 8 log
<number3> delay
83